Beautiful Signs for a Better Planet
Our suggested method is to install a Green Dot sign via four eco-friendly wood pegs. This method works well with textured and standard walls.
Test low tack tape on an inconspicuous part of your wall to be sure it doesn’t remove paint. If necessary, sign installation pattern can be held by hand.
Printed versions of these installation patterns are always included with your sign when it is shipped. If you download and print patterns from our website and intend to use them, it is critical that you print on the correct paper size and at actual size. The 7.25″ x 4″ and 7.25″ x 9.25″ signs are set for 8.5″ x 11″ paper and the remaining sizes on 11″ x 17″. If sized incorrectly holes may be drilled in the wrong location.
No one wants an extra hole in the wall, right?
Position hole pattern on wall, confirming it is level and ADA-compliant. Tape pattern to wall.
Using 5/16” bit, drill through template and into wall at each dot. Then remove template.
Confirm holes line up with pegs, and wallow out holes as needed.
Apply silicone on four pegs and in a small circle on sign back.
Insert sign into wall holes. Press against wall and hold for 10 seconds.
Admire your work (briefly…) then install your next sign!